Contact  
 

Neoprene Overhead Light Streamers
 
Cat No Length Lights Wiring Devices
51100
51150
100ft
50ft
10
5
20 amp 120 volt twist-to-lock
51200
51250
100ft
50ft
10
5
15 amp 120 volt Straight Blade U-Ground
 
  • These molded lighting streamers  conform to OSHA requirements.
  • Neoprene composition molded to 12/3 SO UL listed Cord.
  • Each socket fabricated with crush resistant protection.
  • 100% Factory inspection
  • Neoprene lips on socket from compression, moisture proof barrier on neck of the bulb.
  • Heavy duty, solid contact, porcelain based lamp holder rated at 660 watts.
Specials 10/3, 12/4 or 10/5 special light streamers are available. For 3 wire light lines, the 10/3 offers less voltage drop over extended runs. With a 4 wire 125/250 volt circuit, we can place the first light bulb between L1 and neutral and the second light bulb between L2 and neutral and then repeat; this too permits longer runs.
With a 5 wire 3 Ø circuit, we have the advantage of putting the first bulb between L1 and neutral and then into L2 and L3 before we repeat L1.
 

Lamp Guards
   
CAT NO 51001
This transparent guard will not cause shadows and is made from tough, crush-proof polycarbonate. It features a weatherproof design to protect lamp. It is designed to slip over the light socket after which the interaction of the bulb and the neoprene socket locks the guard in place.
CAT NO 51003
Vinyl covered metal guard. Comes complete with bolts and nuts to attach to socket.
CAT NO Inexpensive Clam shell design vinyl guard. Easily attaches with Screw Clamp. Snaps open and shut for bulb replacement.
 

Yellow Vinyl Overhead Light Streamers
 

12/3 SJTW Yellow Overhead Light Streamers with Guards
Cat No
Length
Lights
Wiring Devices
Guards
PKG
WT
51105
100ft
10
20 amp 120 volt Twist-to-Lock
51005
1
20
51107
51003
1
21
51155
50ft
5
20 amp 120 volt Twist-to-Lock
51005
2
20
51157
51003
2
21
51205
100ft
10
15 amp 120 volt U-Ground
51005
1
20
51207
51003
1
21
51255
50ft
5
15 amp 120 volt U-Ground
51005
2
20
51257
51003
2
21
 

Explosion Proof Overhead Light Streamers
 

Design your own 12/3 SJ Light Streamer.

  1. Specify the overall length.
  2. Specify where the "T"s are to be located.
  3. Specify how long the "T" drop should be
Because of the light streamers  will be special we cannot assign a catalog number to the cordsets: we do however assign number 51701 to the "T".
These "T"s are of heavy construction; the thickness of the area designed to support the weight of the lamp is a full 1/2 inch and easily passes the U.L 30lb. Dead weight test.
If you wish, we will supply fixtures. plugs and connectors, or you can supply your own.