Contact  
 

Tent Crown Light Fixture

   

Rental Centers that have a party rental business have had to rig clip-on light fixtures to their tent poles as a means of illumination. This was felt to be very unsatisfactory, not only for safety reasons, but also it did no seem to reflect a professional image. At the request of some of thesed rental centers we developed the unit shown installed on one of the tent crowns commonly used in the industry.

 

Features

  • Cast Aluminum, gasketed box
  • 20 feet of 16/3 SJT cord which is long enough to reach from the crown, down the rafter and connecting post to the ground. Complete with U-Ground 15amp 120 volt molded plug.
  • A Dimmer/on-off switch installed in-line conveniently located close to the plug.
  • Comes supplied with necessary hardware, so that it is easy to attach to the two crown fixture shown on this page. WE DON NOT furnish the crown fixtures.
  • Furnished complete with the appropriate PAR-30 120 volt flood lamps.
Three Models are available
Cat No Description
51800 is illustrated at the botom and has two lamps.
51805 is identical to 51800. However, it has tree lamps.

51808

 

 is identical to 51800 and, in addition, it has a hook and plug-in for hanging and illuminating chandeliers and Motor-drive reflecting globes.
The crown fixture shown to the right should be altered slightly for best results. There are eight raised bosses around the bottom inside edge of the fixture. Grind any single boss down and then grind the opposite boss (180 Degrees away) in a similar fashion. The Tent Crown Fixture will then rest properly on the flat area created.