Contact  
Finger Grips
Bulk Electrical Cable
Wiring Devices
Wiring Devices for 250 Volt 3 phase
European Wiring Devices
Shrink Tubing
Molded "Y"s, 3 Conductor
Molded "Y"s, 4 Conductor w/Ground Fault
Molded "Y"s, 3 Conductor w/o Ground Fault
Extension Cords
Extension Cords for 250 volt 3 phase
Duo-Meter
Duo-Meter for 250 volt 3 Phase
Clamp-on Floodlight
15 % Boosters for 250 volt 3 phase
Voltage Booster, 3 Wire
Voltage Booster, 4 Wire
Voltage Booster, 110volt System
Power Supply Transformers
Step-Down Transformer
Step-Down Transformer for 3phase
Voltage X 2
Multi-Step Bucking Transformer
Motor Control Center for Hoists
"Eddy" Hook-Ups
 
Motor Control Center for Multiple Hoists
 
This unit has been designed for hoisting re-enforced plastic sheets used for building enclosure/material containment. We have controlled as many as 12 multi-point hoists and can easily do more. Each hoist can be individually controlled. Once the proper tension has been achieved, a “Joy stick” is then given control over all of the hoists. When necessary, any individual hoist can be “tweaked” to obtain the correct tension.
 
Features

A) Power Supply Connections are located in the rear (not shown)
B) The complete unit has a Master Breaker for Protection and Shut Off
C) Each hoist motor has Breaker protection.
D) Shown are the six Down Buttons that are provided to “tweak” any of the hoist motors that require a downward movement to provide proper tension.
E) Shown are the six Up Buttons that are provided to “tweak” any of the hoist motors that require an upward movement to provide proper tension.
F) Control toggle switches remove control from the Up and Down buttons and give control to the “Joy Stick”.
G) Indicating lights signal that the hoist motor is properly connected to the system. It shows (a) that the Power Supply Cord is properly connected and (b) that the control cord is connected. If either or both are NOT connected, the light will NOT be on.
H) Power cord outlets(six each) have three per side (one side hidden in drawing)
I) Control Cord Inlets are provided (six each) with three on each side (one side hidden in drawing)
J) Emergency Stop. Stops operations of all hoists.
K) Joy Stick Master Control. With toggles in the “up” position, the “Joy Stick” takes over. It has three positions: Up, Down and Off. When removing manual control, the “Joy Stick” automatically moves to the “Off” position.
L) The swing-out panes is hinged and provides east access to the inside components.
M) The term NEMA 12 indicates an enclosure that is rainproof, sleet-proof, dust tight and oil tight
The above is pre-engineered, pre-assembled and is all set to go!
 
Accessories
Each hoist requires a pair of extension cords i.e. A power extension cord and a control extension cord.
 
Conversion Kits for Push-Button Enclosures
A kit for each hoist is composed of a plug, connector, boots plus instruction. The purpose of the kit is to permit an easy return of the hoist motors to your regular inventory once the job is finished and an equally easy return to another multiple-point job in the future.